HOME  |   ABOUT US  |   VACANCIES  |   CONTACT US  
AMS No-Dig Directional Drilling and Auger Boring Specialists
  HOME | DIRECTIONAL DRILLING | GUIDED AUGER BORING | ACCREDITATIONS |  FLEET |  EQUIPMENT SALES |  CASE STUDIES  
  GUIDED AUGER BORING  |   GUIDED AUGER PROCESS   |   NON GUIDED AUGER PROCESS  
 
 
 

Guided Auger Boring

Guided Auger Boring can provide a solution in situations where HDD cannot be utilised, where set up room is limited or in situations where levels are critical.

Traditionally this technique has been used in the installation of vitrified clay gravity sewers but is being applied increasingly in the installation of steel sleeves used to carry utility installations.

The AMS No-Dig fleet has the capacity to install product up to 900mm in diameter and up to 120m in length, subject to ground conditions using Guided Auger Boring.

We can install Denlok sizes as follows:
  • DN150 (6")
  • DN225 (9")
  • DN300 (12")
  • DN450 (18")
  • DN500 (20")
  • DN600 (24")
  • DN700 (28")
Guided Auger Boring Process

  

Click on the play button below to watch the video
(with audio commentary)

Guided Auger Boring Method

BM400LS Directional Auger Boring Rig
 


 
  AMS No-Dig Ltd, Brigg Road, Scunthorpe, DN16 1AP
AMS No-Dig Ltd is Registered in England No. 02703484 : VAT Registration No.: GB 651 531 457
© 2017 AMS No-Dig Ltd